Nov 8, 2026

What problems should I expect renovating a Victorian house?

The hidden problems that often turn up in a period home, the signs you can safely check and how to budget for them.

What problems should I expect renovating a Victorian house?

The problems most likely to turn up when you renovate a Victorian or Edwardian house are the ones you can't see: old wiring, lead water pipes, damp caused by the wrong materials, rotten timbers and badly supported chimney breasts. Most can be fixed, but they cost far less to deal with when you know about them before work starts.

Below we go through the common ones, the signs you can safely look for yourself, and how to plan your budget around them. One rule applies throughout: if something might contain asbestos, don't drill, sand or scrape it.

Old wiring

Most period homes have been rewired at some point, but not always recently or well. Signs the wiring may be due for replacement include:

  • a fuse box with old fuses that hold a length of wire, rather than switches that flick off
  • no RCD, a safety switch that cuts the power if current leaks to earth
  • sockets set into the skirting boards, or very few sockets in each room
  • black rubber or fabric-covered cable visible in the loft or under the stairs

Electrical Safety First recommends that homeowners have an Electrical Installation Condition Report, an electrician's inspection of the wiring, at least every 10 years and when moving into a home. It tells you whether the wiring is safe and what needs doing. If a rewire is needed, it is done early, before any plastering, so it doesn't damage new walls. Never open the fuse box or sockets yourself.

Lead water pipes

Houses built before 1970 may still have lead pipes bringing water in. Lead can dissolve into drinking water, so it is worth checking. Find the pipe going into your stop tap, often under the kitchen sink. A lead pipe is dull grey and soft, and if you gently scratch it with a coin, it shows shiny silver underneath. Copper is brown, and plastic is usually blue or black.

The pipe within your property boundary is usually your responsibility, so a renovation, when floors are already up, is a good time to replace it.

Damp caused by the wrong materials

Victorian walls are usually solid brick with no cavity, built with lime mortar and often lime plaster. They absorb some moisture and let it dry out again. Cement render, cement pointing, modern gypsum plaster and plastic-based paints can trap that moisture, leading to damp patches, flaking paint and crumbling plaster.

Before any damp treatment, the cause needs finding. It is often outside: a blocked gutter, a leaking downpipe, or a path or flowerbed built up above the damp-proof course, the waterproof layer near the bottom of the wall. Walk round the house during or after rain and look for overflowing gutters and wet patches on the brickwork. When walls are replastered as part of our interiors work, the plaster needs to suit the wall it goes on.

Rotten timbers under floors and above windows

Many Victorian ground floors are suspended timber, with floorboards on joists over a void. Air bricks, the small vented bricks near the bottom of the outside wall, let air through to keep the joists dry. When they are blocked by render, a raised patio or plants, the joists can rot. Timber lintels, the beams above windows and doors, can rot behind the brickwork too.

Signs include a floor that feels bouncy or slopes, a musty smell, and cracks running up from the corners of windows. You can safely check that your air bricks are clear and not covered, but leave anything structural to a professional.

Chimney breasts with missing support

In many Victorian terraces, chimney breasts were removed downstairs decades ago. If the breast above, upstairs or in the loft, was left without proper support, it can be resting on very little. A chimney breast upstairs with nothing beneath it is a sign to get it looked at.

Removing or supporting a chimney breast needs a structural engineer's design and Building Control sign-off. In a terrace or semi, it is usually on a shared wall, so you will need to serve a Party Wall notice on your neighbours. Chimney breast work is part of our structural building work.

Asbestos in later alterations

Victorian houses weren't built with asbestos, but most were altered during the 20th century. The Health and Safety Executive advises that any building built or refurbished before 2000 may contain it. In homes, it can turn up in textured ceiling coatings, old floor tiles, boxing around pipes, old flue pipes and garage roofs.

Asbestos is only dangerous when it is disturbed and its fibres get into the air. If you suspect it, leave it alone and have a sample tested by a qualified asbestos surveyor before any work starts.

Planning your budget for what you can't see

Some problems only show once floorboards are lifted or old plaster comes off. A few steps make them easier to handle:

  1. Have a survey done before you buy, and read the sections on damp, timber and services closely.
  2. Build a contingency into your budget for things found during strip-out.
  3. Agree with your builder, before work starts, how hidden problems will be priced.

On our renovations, we price what we can see at the initial survey. If we find rotten timbers, failed pipework or asbestos once walls are opened, we stop, show you what we have found, talk through the options and agree any extra cost before carrying on. If you are buying a house that needs work, we can also walk round it with you first.

Riverside Construction Group renovates period homes across Kingston and Wimbledon, from single rooms to whole-house refurbishments. If you are planning work on an older house, start with a survey visit for our home renovation service, so the hidden problems are on the table before the work is priced.

‍

Contact us

Ready to transform your home?